Adam Equipment HIGHLAND SERIES Spécifications télécharger pdf (Page 15)

13 | P a g e © Adam Equipment Company 2011

6.0 PARAMETERS

The balance has 7 parameters that can be set by the user.

FUNCTION SECTION DESCRIPTION

F1 UNT

See section 6.1 Sets the units to be used

ct / Lb / oz / d / GN / OZt / dWt / MM / TL.T / TL.C / TL.t /t

/ N /g2.

F2 EL

See section 6.2 Sets the backlight

EL on

: backlight always on

EL AU

: backlight automatically turns on when a key is

pressed

EL oFF

: backlight always off

F3 SEr

See section 6.3 Sets the print parameters

F4 oFF

See section 6.4 Sets the auto power-off parameter

F5 IEC

See section 6.5 Internal or external calibration select

F6 CA

See section 6.6 Cal mass fine adjust

F7 SEt

See section 6.7 User Parameters for autozero, filter and stability

tECH

Technical parameters setting mode / factory setting

6.1 ENABLING

WEIGHING

UNITS

You can enable and disable the weighing units available to the user when they press

the [Mode] key as described in section 4.5 Weighing Units.

1) To set this parameter press and hold the [Mode] key during self-checking test

when turning on the balance.

2) After a few seconds, the display will show the first function F1 UNT.

3) Press the [Tare] key to view the current settings of each unit.

4) Pressing the [Tare] key will cycle through the other units along with their

current settings. For example, if oFF is displayed with the weighing unit Carats,

the user will not be able to use this unit while weighing.

5) Pressing the [Mode] key will change the setting of a particular unit. For

example, to enable the weighing unit Carats, change the setting to on by

pressing the [Mode] key.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Adam Equipment HIGHLAND SERIES Spécifications Page 15

Commentaires sur ces manuels

Produits connexes et manuels pour Balance de cuisine Adam Equipment HIGHLAND SERIES